I love puzzles, I do. Puzzles are both brain-food and art. I love to assemble puzzles, but on their own, puzzles as art is ephemeral. Thus…Glue! There are now a ton of different ways to preserve a puzzle, and I’ll most likely do posts on them as I try them. But, when I grew up, the only option was glue.
I tried a few different brands until I found Mod Podge. I love this stuff! They have nearly a dozen variations now, but I tend to stick to either Matte or Satin. Satin is my go-to. It goes on smooth, and if I take my time, the brush strokes disappear.
Anyways, my process for gluing a puzzle is simple.
I assemble my puzzles on a piece of foam board. I cut out enough wax paper to cover the whole puzzle. Tape these together with a good bit of overlap on the edges.
Place the wax paper over the image side of the puzzle and top with a second foam board.
With the puzzle sandwiched in between the foam boards, flip it upside down.
Now it’s time for Mod Podge! Much like with painting, always keep a wet edge. Which means; once you start, you have to finish! I start by laying a thin line of Mod Podge the entire length of the top about 2 inches from the edge.
Using a paintbrush(I like these thick foam ones), spread the Mod Podge in an even layer with long strokes. Don’t worry, it starts white, but dries clear. Continue to add lines of Mod Podge and brush it across the puzzle until it is completely covered.
Then set it aside in a warm, dry place where it will not be disturbed. Because I have cats, this is usually my laundry room. It only takes about 20-30 minutes to dry, but I like to wait a day in between coats. I recommend at least 2 coats on the back and one on the front. To remove any stickiness, Mod Podge’s website recommends finishing with an acrylic urethane spray. I haven’t tried that yet, once I do, I’ll update this post with my opinion.
Disclosure: I bought the Mod Podge featured in this post. All opinions are my own.
Mod Podge™ is copyright http://www.Plaidonline.com
Thanks for reading, and please click the Follow Button under my profile on the right side of the page. To support posts like this in the future, consider joining my Patreon!